Surface Mount LED Panels

The LED Panel Surface Mount Kit allows all edgelight LED panel, backlight LED panel and LED troffer lights to be installed directly against the ceiling in environments where a recessed (t-bar) ceiling is not present.

• Mount LED panels directly underneath a variety of ceiling types.
• Suits all EU and US standard LED Panel lights.
• Slim 50mm and 70mm height.
• Durable aluminium, powder-coated white.

Specifications -  LED Panel Surface Mount Kit

How to Install the LED Panel Surface Mount Frame

The installation guide (PDF above) provides a visual representation of the following steps. All required parts (brackets, screws, mounting wires, and plugs) are included in the kit.

1. Switch off power to the lighting circuit.
2. Remove screws on the back of the LED panel in the 6 locations as indicated.
3. Attach the 6 mounting brackets in these locations.
4. Separately, place the frame on the ceiling in the desired location. Mark the 4 drill holes on the ceiling as indicated.
5. Drill the 4 mounting holes in the ceiling and insert plastic screw plugs.
6. Mount the frame to ceiling with the 4 long screws.
7. Now attached the 2 mounting cables between the LED panel and frame. This allows the panel to hang from the frame whilst the wiring is completed.
8. Unscrew the terminal block cover on the LED driver (which is already pre-wired to the LED panel). This step assumes that you will not use, or at least need to relocate the pre-wired lead and 2-pin plug.
9. Wire-up active and neutral leads as indicated. If required, this part of the installation must be performed by a licensed electrician.
10. Close the terminal block cover.
11. Adjust the location of the mounting cables if required.
12. With the LED panel in place on top of the mounting frame, insert the 6 blunt ended fixing screws.
13. Turn power back on to the lighting circuit.
14. Enjoy your energy saving surface mounted LED panel light!